Short answer: Installation connects the new water heater to the water supply, drain, and power or gas source, following the specific venting and clearance requirements for the unit type chosen.
This page covers water heater installation as the final step after repair and replacement have already been weighed. It applies whether the new unit is going into the same spot as an old one or into new construction.
Because gas and electrical connections are involved, along with proper venting, installation is one area where getting the details right matters for both performance and safety.
Signs You May Need This Service
- Water that takes longer to heat up or never gets fully hot
- Lukewarm water that runs out faster than it used to
- Rumbling, popping, or banging sounds from the tank
- Water with a rusty tint or a metallic smell
- Moisture or pooling water around the base of the unit
What the Service Typically Involves
- Inspecting the tank, connections, and heating element or burner
- Testing the thermostat, pressure relief valve, and anode rod
- Flushing sediment buildup that reduces efficiency
- Comparing repair cost against the cost of replacement for older units